32 / 56
PL
SK
DE
EN
CS
HU
2. When starting cold engine, press the primer bulb 3x-5x times before starting the engine
(fig. 17A). If the engine is warm, push the primer only once.
3. Standing behind the mower, grasp the brake control handle (fig. 18A) and hold it against
the upper handle as shown in.
4. Grasp the starter handle (fig. 18B) and pull gently on the starter handle until it begins to
resist, then pull quickly and forcefully upwards.
CAUTION! A
Do not allow the starter grip to snap back against the engine. Return it gently to
prevent damage to the starter.
CAUTION! A
Rapid retraction of starter cord (kickback) will pull hand and arm toward engine
faster than you can let go. Broken bones, fractures, bruises or sprains could result.
5. Return the starter handle slowly to the rope guide bolt after engine starts.
6. Release the stop control handle to stop the engine and blade quickly if necessary.
• Do not tilt the lawn mower when starting the engine. Start the mower on a level surface,
free of high grass or obstacles.
• Keep hands and feet away from the rotating parts.
• Do not start the engine when standing in front of the discharge opening.
BRAKE HANDLE
CAUTION! A
In order to avoid any unintentional start-ups of the lawn mower, it comes equipped
with an engine brake.
• The engine brake is a basic safety feature of the mower. When the brake lever is released,
the engine and the blades must automatically stop. The deceleration time depends
on the condition and wear of the brake. If the brake doesn’t work properly, contact an
authorised service centre.
• Before mowing, you should check the brake function several times to make sure everything
is in correct working order.
C During operation, hold the handle and the brake control lever firmly. If you release
the brake lever during the machine’s operation, the engine stops.
TO STOP ENGINE
WARNING! B
The blade continues to rotate for a few seconds after the engine is shut off.
To Next Page
