EasyManua.ls Logo

hecht 5433 SW - Technical & Consumer Information; Service and Spare Parts

hecht 5433 SW
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
48 / 56
PL
SK
DE
EN
CS
HU
Engine does not
start.
Carburetor is flooded with fuel
Remove air filter element, spark plug and pull
starter rope continuously until carburetor clears
itself and install air filter element, and cleaned
spark plug back. Start without pressing primer.
Faulty ignition module Contact the authorized service agent.
Engine difficult
to start or loses
power.
Dirt, water, or stale fuel tank.
Drain fuel and clean tank. Fill tank with clean, fresh
fuel
Vent hole in fuel tank cap is
plugged
Clean or replace fuel tank cap.
Air filter element is clogged. Clean air filter element.
Engine operates
erratically.
Spark plug is defective. Install new, correctly gapped plug
Spark plug gap is incorrect.
Set the correct gap between the electrodes - see
Specifications
Air filter element is clogged. Clean air filter element
Engine idles poorly.
Air filter element is clogged. Clean air filter element
Air slots in engine shroud are
clogged.
Remove debris from slots.
Cooling fins and air passages
under engine blower housing are
clogged.
Remove debris from cooling fins and air passages.
Engine skips at
higher speeds.
Gap between electrodes of spark
plug is too close.
Set the correct gap between the electrodes - see
Specifications
Engine overheats
Cooling air flow is clogged.
Remove any debris from slots in shroud, blower
housing, all air passages
Incorrect spark plug. Install original spark plug.
Mower vibrates
abnormally
Cutting assembly is loose. Tighten blade
Cutting assembly is unbalanced Balance blade.
TECHNICAL & CONSUMER INFORMATION
SERIAL NUMBER LOCATION
Record the engine serial number (fig. 42A) in the space below. You will need this information
when ordering parts and when making technical or warranty inquiries.
Engine serial number:_______________________
SERVICE AND SPARE PARTS
• In the event of a fault, we recommend having this product repaired by an authorised service
centre, which uses only identical spare parts. You will maintain both the product’s safety
and its performance.
• For technical assistance, repair or to order original spare parts, we recommend that you
always contact the nearest HECHT authorised service centre.
• Information on service locations, visit www.hecht.cz
• When ordering spare parts, please quote the part number, this can be found at
www.hecht.cz

Table of Contents