40 / 56
PL
SK
DE
EN
CS
HU
3. Remove the oil filler cap/dipstick (fig. 31A).
4. Remove the drain bolt
(fig. 32A) and washer (fig. 32B) and allow the used oil to drain
completely into the container.
5. For engine without drain plug, we recommend to use oil extractor pump
(fig. 33), or drain
the oil into the container by slightly tilting the engine toward the oil filler cap/dipstick
(fig. 34). Before tilting the machine, remove fuel from tank. Keep the spark plug end of
the engine up.
C Please dispose of used motor oil in a manner that is compatible with the environment.
We suggest you take used oil in a sealed container to your local recycling center or
service station for reclamation. Do not throw it in the trash or pour it on the ground
or down a drain.
6. Reinstall the drain bolt. With the engine in a level position, fill to the upper limit mark on
the dipstick with the recommended oil.
CAUTION! A
Running the engine with a low oil level can cause engine damage.
7. Reinstall the oil filler cap/dipstick securely.
CAUTION! A
Wash your hands with soap and water after handling used oil.
AIR FILTER
A dirty air filter will restrict air flow to the carburetor and cause poor engine performance.
Inspect the air filter each time the engine is operated. You will need to clean the air filter more
frequently if you operate the engine in very dusty areas.
CAUTION! A
Operating the engine without an air filter, or with a damaged air filter, will allow dirt
to enter the engine, causing rapid engine wear. This type of damage is not covered.
AIR FILTER INSPECTION AND CLEANING
CAUTION! A
The air filter must be serviced (cleaned) after 25 hours normal working. Service more
frequently when operating the machine in extremely dusty areas.
Determine the type installed on your engine and service as follows.
Shut off the engine before performing any service on the machine. Wait till all moving
parts are completely stopped and disconnect the spark plug.
To Next Page
