35 / 56
PL
SK
DE
EN
CS
HU
• To avoid stirring up the dust, mow the grass best when it´s is dry, but the soil is still moist.
Dust causes the air filter pollution.
• Ground speed will need to be adjusted so the clippings can be dispersed evenly into the lawn.
• For especially heavy cutting in thick grass it may be necessary to use one of the slowest
speeds in order to get a clean well mowed cut. When mowing long grass you may have to
cut the lawn in two passes, lowering the blade another 1/3 of the length for the second cut
and perhaps cutting in a different pattern than was used the first time.
• Cut the grass regularly. With respect to the lawn, do not cut by more than 1/3 of the total
height (to prevent it from withering). However, cut the grass by approximately 2 cm (i.e.
shorten it from 6 cm to 4 cm, for example).
• Always keep the edge of the cutting blade sharp.
• Only move at working pace.
• Always keep the grass ejection hole clean and clear. Remove cut material only when
the equipment is stopped.
• Overlapping the cut a little on each pass will also help to clean up any stray clippings left
on the lawn.
• The mower should always be operated at full throttle to get the best cut and allow it to do
the most effective job of mowing.
• The mowing of leaves can also be beneficial to your lawn. When mowing leaves make sure
they are dry and are not laying too thick on the lawn. Do not wait for all the leaves to be off
the trees before you mow.
CAUTION! A
If you strike a foreign object, stop the engine. Disconnect wire from spark plug,
thoroughly inspect the mower for any damage and repair the damage before
restarting and operating the mower. Extensive vibration of the mower during
operation is an indication of damage (especially blade and shaft). The mower should
be promptly inspected and repaired. Contact an authorized service center.
5 IN 1 FUNCTION
5 in 1 = mowing, self propelled, grass collection, mulching, side discharge.
The mower can be converted to other uses. From a lawn mower with rear shovelling to
the mower with a side discharge or a mulching mower.
CAUTION! A
DO IT ONLY WITH A STOPPED MOTOR AND STANDSTILL CUTTER!
MULCHING MOWER
(the grass is cut in one working step, then finely chopped and returned to the grass
strip as natural fertilizer)
1. Raise the rear cover and remove the grass catch bag.
2. Push the mulching wedge into the deck (fig. 27A).
3. Lower the rear cover again.
To Next Page
