44 / 56
PL
SK
DE
EN
CS
HU
• Allow muffler, engine cylinder and fins to cool before touching.
• Remove accumulated debris from muffler area and cylinder area.
Note: I
Do not use water to clean the engine. Water could contaminate the fuel system.
Use a brush or dry cloth to clean the engine. This is an air cooled engine. Dirt or debris
can restrict air flow and cause the engine to overheat, resulting in poor performance and
reduced engine life.
ENGINE BRAKE / FLYWHEEL BRAKE
Periodically check that the brake is working properly. Pay attention to the proper maintenance
of the brake. Maintenance and repairs of the brake can only be performed by an authorized
service center.
C Attention! Never use a mower with damaged or long time reacting flywheel brake.
ENGINE ADJUSTMENTS
Note: I
Do not change in any way the rated speed of the engine (carburetor side or regulator
side).
Your engine was adjusted in the factory and the non-respect of the homologation speed engine
could be dangerous for your safety and others safety. If the motor settings is changed in any
way, the warranty will be cancelled.
STORAGE
CAUTION! A
Store this machine on place where the fuel vapors can not be in reach of open fire or
sparks. Let the fuel to run dry before long storage. Always let the machine get cool
before storing.
• Store the machine in a dry, clean and frost-protected place, out of reach of unauthorized
persons.
• Be careful not to bend or kink cables.
• Replace worn or damaged parts for safety. Use only original spare parts.
ENGINE STORAGE
PREPARATION
Proper storage preparation is essential for keeping your engine trouble free and looking good.
The following steps will help to keep rust and corrosion from impairing your engine‘s function
and appearance, and will make the engine easier to start when you use it again.
CLEAN THE MACHINE BEFORE STORING ACCORDING TO THE PARAGRAPH
MAINTENANCE / CLEANING.
To Next Page
