18 / 33
PL
SK
DE
EN
CS
HU
• Remove accumulated debris from muffler area and cylinder area. Inspect the muffler for
cracks, corrosion, or other damage.
• Check the machine before an each use to determine whether the working tools are not
worn or damaged. Replace worn or damaged parts.
ELECTRICAL SAFETY
WARNING! B
Do not connect a damaged cable or touch the damaged cable before disconnecting
from the network. This can cause an electric shock. In case of damage to the supply,
have it replaced by an authorized service centre. This prevents a dangerous situation.
• Protect yourself against electric shock.
• Protect the supply and extension cable against heat, aggressive liquids and sharp edges.
When unplugging, do not pull the cable.
• Do not expose to rain or use in damp or wet conditions.
• Do not use in environments with a risk of fire or explosion.
• Never handle the supply cord or pull the plug from the socket by pulling the cable.
• Regularly check the supply cable and check for signs of damage or aging.
• Avoid accidental starting.
• Use only extension cables with sufficient section, which are approved for this purpose and
labelled accordingly.
• Cable drum before using completely unwind.
• Prevent spontaneous fall of small objects into the product.
• Do not use if the switch does not ensure trouble-free turning on and off.
• Never use brute force.
• The construction is done in accordance with all applicable safety requirements that apply to it.
• Disconnect the supply (by pulling out the plug from the socket for example):
- Allways, when the machine is without supervision
- Before eliminating of blocking
- Before checking, cleaning or work on the machine
- After crash into another subject
- Allways, when the machine beginns vibrate unreasonably
- When transporting
ELECTRICAL REQUIREMENTS
The 1-phase motor splitter is designed for connection to a standard electricity network. (230V
± 10% / 50 Hz ± 1 Hz). Machines should be fed through a current protector (RCD) having
a tripping current of less than 30 mA. Use a 3-lead extension cable for connection. (P + N + PE).
The mains connection must be protected with a 16 A circuit breaker. Connect the rubberised
electrical cables with a minimum cross-section corresponding to the machine input. Symbol H
07 RN must be in accordance with EN60245.
Note: I
Only connect the machine to an electrical power source that has been properly
revised. Check with your local Electricity Board or electrician if in doubt whether your house
service connection meets these requirements.
EXTENSION LEAD
• Always use a double-insulated power supply and the parameters corresponding to
the machine’s power consumption. The minimum cross section of the cable must be determined
To Next Page
Loading...