hecht 670 - CLEANING; REPLACING HYDRAULIC OIL; SHARPENING WEDGE; STORAGE

26 / 33
PL
SK
DE
EN
CS
HU
CLEANING
CAUTION! A
Never spray the product with water or expose it to water.
C Never use aggressive detergents or solvents for cleaning.
1. Carefully clean the machine after each use.
2. Do not let the handles contaminate with oil or grease. Clean the handle clean with a damp
cloth washed in soapy water. Never use aggressive detergents or solvents for cleaning. This can
cause irreparable damage to the product. The plastic parts can be eaten away by chemicals.
3. Wipe down the product with a slightly damp cloth or with brush.
4. Clean the cover of the machine, especially the ventilation holes.
REPLACING HYDRAULIC OIL
The hydraulic system is a closed system with oil tank, oil pump and control valve. Check oil level
regularly with dipstick. Low oil levels can damage the oil pump.
First oil change after 25-30 operating hours, then annually.
C Make sure moving parts stops and the log splitter is unplugged. Make sure that no
dirt or debris finds its way into the oil tank.
• Place a container of oil under the splitter with a capacity of at least one third greater than
the amount of oil specified in the Specification. (fig. 13)
• Tighten the drain screw.
• Loosen the oil tank cap
• Loosen the drain screw so the oil can flow out.
• After emptying the oil tank, reassemble and tighten the drain plug.
• Using a funnel, pour new hydraulic oil into the machine. The quantity required is specified
in the Specification.
• Tighten the oil tank cap
• Dispose of old oil according to the law (hazardous waste collection point).
After changing the oil, refer to the section “CHECK / POUR HYDRAULIC OIL”
SHARPENING WEDGE
This log splitter is equipped with reinforced splitting wedge which blade is specially treated,
After long periods of operation, and when required; sharpen the wedge using a fine-toothed file
removing any burrs or flat spots on the edge.
STORAGE
• Store the machine out of reach of children.
• Turn the motor off and disconnect the mains plug if the machine is not used.
• Allow let the machine to cool down before storage.
• Do not store the machine a long time in direct sunlight.
• Replace worn or damaged parts for safety.
• Store machine in a clean, dry, dark and frost-free place, protected from dust and out of
reach of children. The ideal storage temperature is between 5 and 30°C.
• Use the original packaging to storage whenever possible.