15 / 32
PL
SK
DE
EN
CS
HU
CONDITIONS OF USE
WARNING! B
PLEASE READ THE OPERATING INSTRUCTIONS! Read all instructions before operation.
Pay special attention to safety instructions.
FAILURE TO FOLLOW THE INSTRUCTIONS AND FAILURE TO RESPECT SECURITY
MEASURES MAY RESULT IN DAMAGE OF THE PRODUCT OR SERIOUS INJURIES OR
EVEN FATAL INJURY.
If you notice any damage during transport or unpacking, notify your supplier immediately. DO
NOT PUT INTO OPERATION.
The machine belongs to the mechanical group M1.
SPECIFIC TERMS AND CONDITIONS OF USE
This product is exclusively intended for the use:
- for lifting and lowering loads corresponding to the capacity of the machine in enclosed
spaces.
- for private use only
- according to the corresponding descriptions and safety instructions in these operating
instructions.
Any other use is not as intended.
C The machine is not suitable for transporting hot and/or molten materials and is also
not suitable for use at low temperatures or in aggressive and explosive environments.
If the product is
- used other than for the intended purpose
- put into operation with a visible defect or after incomplete or unprofessional assembly
- used with accessories that are not recommended in this manual
- unprofessionally repaired or modified
the statutory warranty and defects liability as well as any liability on the manufacturer’s part
expires.
C The user must not handle parts and settings that are sealed by the manufacturer or
their representative!
Do not overload! Use the product only for the powers it was designed for. The product
designed for a given purpose performs it better and safer than one that has a similar function.
Therefore, always use the correct one for a given purpose.
Please keep in mind that our products are not designed for commercial, trade or industrial use
according to their intended purpose. We accept no liability if the product is used in these or
comparable conditions.
Where it is required, follow the legal guidelines and regulations to prevent possible
accidents during operation.
To Next Page
Loading...