EasyManua.ls Logo

hecht 8425 - Protective Equipment

hecht 8425
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
17 / 32
PL
SK
DE
EN
CS
HU
Pay attention to what you are doing, be concentrated and think sensibly, do not work with
the product if you are tired, under the influence of alcohol, drugs or medication.
Faulty switches must be entrusted to an authorised repair service for replacement.
Do not use this product if the main switch does not allow it to switch on or off.
This product is designed in accordance with all applicable safety requirements and standards
applicable to it. All repairs should be only made by qualified person and spare parts replaced
by original parts, otherwise the user may be in serious danger.
Read and learn the operating instructions before using the rope hoist.
Ensure that the operator has sufficient awareness of how the machine works and how it is
to be operated.
The user should always operate the machine as described in the operating instructions.
It is necessary to:
- always work in accordance with the operating instructions
- lift the load at the minimum usable speed
- keep the lifting rope (chain, belt) taut when lifting, it must not come loose or sag
- observe the maximum load capacity of the device and not try to lift loads that are
heavier
- not try to lift loads that are fixed to the ground or difficult to access
- avoid side pulls or pulling loads horizontally
- avoid tugging at the rope (e.g., the engine cannot be switched on and off impulsively)
- comply with the ban on lifting people.
- maintain a safe distance from the area above which the load is lifted.
WARNING! B
Never lift people or live animals.
Never enter the area under the load.
The lashing accessories used (attachment point) and the hanging accessories (auxiliary
pulleys) must have a rated capacity at least 2 times higher than the maximum permissible
load capacity for lifting loads.
All hanging and lashing accessories must be fitted with a safety device against accidental
slipping and opening.
The rope hoist is not designed for continuous operation. Its mode of operation is:
intermittent mode without affecting the starting process.
The rated capacity of the machine does not change depending on the position of the load.
Check the hook before using the machine. If it shows possible damage or is distorted,
replace it in good time.
The service life of the rope hoist is approximately 8,000 cycles (excluding wear parts). Once
the hoist exceeds 8,000 cycles, all its mechanical parts must be checked and repaired.
PROTECTIVE EQUIPMENT
Wear eye protection! The operation of machine can result in foreign objects being thrown
into your eyes which may result in severe eye damage. Normal glasses are not sufficient
for eye protection. For example, corrective glasses or sunglasses do not provide adequate
protection because they have not special safety glass and aren’t enough closed from the sides.