24 / 32
PL
SK
DE
EN
CS
HU
PROBLEM PROBABLE CAUSE CORRECTIVE ACTION
The operating
switch is closed, but
the motor does not
rotate
Limit bracket switches are not
closed or limit switch error
Check limit switches. Have them replaced in
the event of a failure.
Equipped with thermal fuse.
Wait for the product to cool, or have the thermal
switch replaced.
The operating
switch is closed.
The motor is very
noisy and the load
cannot be lifted
Low mains voltage Ensure proper power supply.
Defective starting capacitor
Have the machine repaired in a qualified repair
shop.
The brake is not fully released
The load slides
down after
disconnecting/
stopping the motor.
Brake failure Have the machine repaired by a qualified workshop.
The machine makes
unusual noises
Poor lubrication Lubricate the machine according to the instructions
Worn gears and bearings.
Have the machine repaired by a qualified workshop.
Damaged parts
The machine has
faulty insulation
Earthing fault or no earthing. Check the earthing and connect it properly.
The inner connections touch
the cover
Have the machine repaired by a qualified workshop.
Limit switch not
functional
Have the machine repaired by a qualified workshop.
SERVICE AND SPARE PARTS
• In the event of a fault, we recommend having this product repaired by an authorised service
centre, which uses only identical spare parts. You will maintain both the product’s safety
and its performance.
• For technical assistance, repair or to order original spare parts, we recommend that you
always contact the nearest HECHT authorised service centre.
• Information on service locations, visit www.hecht.cz
• When ordering spare parts, please quote the part number, this can be found at
www.hecht.cz
DISPOSAL
• Dispose your device, accessories and packaging in accordance with the requirements of
environmental protection into the recycling collection center.
• This machine does not belong to the household waste. Save the environment and take this
device to designated collection points where it will be received for free. For more information
To Next Page
Loading...