25 / 36
Note: I
In case of doubt, check with your electricity supplier or with your electrician if your
home connection meets these requirements.
• Place the power cord so that it will not interfere with work and to avoid damage.
• Keep cord from heat, corrosive liquids and sharp edges.
• When disconnecting the power plug do not pull the cord.
• If the power cord is damaged, let it have changed in accredited service to prevent the danger.
• Do not carry or manipulate the machine by power cord, do not pull up the socket inlet from
the socket outlet by pulling the power cord. Protect the power cord against heat, grease
and sharp edges.
UNPACKING
• Carefully remove the product from the box.
• Carefully inspect all parts. If any part is damaged or missing, contact your dealer or
authorized service center.
• Do not throw away packaging materials until you have not reviewed carefully if they did not
remain a part of the product.
• Parts of the packaging (plastic bags, paper clips, etc.) do not leave within reach of children,
could be a possible source of danger.
• Disposal must be made in accordance with the regulations in force in the country in which
the equipment was installed.
• Make sure that bags and containers of plastic material are left strewn freely in the environment
because they pollute it.
• If you have any doubt do not use the machine, but have it checked by an authorized service center.
PACKAGE CONTENTS:
Standard accessories are subject to change without notice.
1x arm with motor, 1x stand, 1x centering pin, 1x screw with hexagonal head, 1x washer, 1x
adjusting wheel, 1x handle, 1x grinding disk protective enclosure, 1x lateral guard of grinding
disk, 1x grinding disk, 1x manual for use
We recommend save the package for future use. The packaging materials must still be recycled
or disposed of in compliance with the relevant legislation. Sort different parts of the packaging
according to material and hand it to the appropriate collection sites. For further information
contact your local administration.
ASSEMBLY
ASSEMBLY ON WALL AND ON THE TABLE
One part consists of the base, on which the chain guide is located.
The other part is a bearing arm with the motor and handgrip.
WARNING! B
The assembly shall be performed with the machine unplugged!
The machine design provides either for a desk installation or wall mounting.
HECHT_9230_manual_2020_EN.indd 25HECHT_9230_manual_2020_EN.indd 25 12.10.2021 15:43:1412.10.2021 15:43:14
To Next Page
Loading...