8
OPERATE NVR SYSTEM
Live Picture
Plug the NVR and cameras in and wait for 2-3 minutes. The live pictures from the
cameras will be displayed on the screen. Then you can connect the mouse to the NVR
and start operating the NVR system.
Notes:
• The default Username for the NVR system is admin, and the default Password is
empty (no need to enter anything);
• This NVR system can be only connected to the network by Ethernet cable currently;
• To protect your privacy, please set the password at your earliest convenience. Right
click the mouse on the main interface, then go to System setup > System Admin >
User > Set password to set a password;
Hard Disk Drive Formatting
Install the HDD first, then right click the mouse on the main interface and go to System
Setup > General Setup > HDD Setup to check its status. If it’s not Formatted, select the
right HDD, then click Format.
To Next Page
Loading...