JS07N·JS07·JS08·JS12·JS14
29
Operating Instruction
5. Replace the two removed pins back into
each side of bracket.
6. At the rear of the main deck, remove the
two main deck lock pins。
7. Fold down the rear gate and entry side
rails as one unit. Keep hands clear of
pinch points.
8. Replace the two removed pins back into
each side of bracket.
9. Fold down right extended platform
guardrail, keep hands free of pinch
points.
10. Fold down the main right guardrails form
the step or the ground. Keep hands free
of pinch points.
11. Fold down left extended platform guard-
rail, keep hands free of pinch points.
12. Fold down the main left guardrails form
the step or the ground. Keep hands free
of pinch points.
13. Replace the two removed pins back into
each side of bracket.
How to raise the guardrails
Follow the folding instructions, but in reverse
order, ensuring all lock pins are in place and
installed properly.
Extension and indented plat-
form
1. Foot the footplate on the extended plat-
form.
2. Push the extended guardrails, and ex-
tend the position you want.
Do not stand on the extended platform when
you try to extend the platform.
Battery and Charger In-
struction
Observe and obey:
√ Do not use an external charger or booster
battery.
√ Charge the battery in a well-ventilated area.
√ Use proper AC input voltage for charging
as indicated on the charger.
√ Use only a authorized battery and
charger.
To charger Battery
1. Be sure the batteries are connected be-
fore charging the batteries.
2. Open the battery compartment. The com-
partment should remain open for the en-
tire charging cycle.
Maintenance-free batteries
1. Connect the battery charger to a
grounded AC circuit.
2. The charger will indicate when the battery
is fully charged.
Standard Batteries
1 Remove the battery vent caps and check
the battery acid level. If necessary, add
only enough distilled water to cover the
plates. Do not overfill prior to the charge
cycle.
2 Replace the battery vent caps.
3 Connect the battery charger to a
grounded AC circuit.
4 The charger will indicate when the battery
is fully charged.
5 Check the battery acid level when the
charging cycle is complete. Replenish
with distilled water to the bottom of the fill
tube. Do not overfill.
To Next Page
Loading...