To Next Page

To Previous Page

2. Change to the “Virtual to Output Routing” matrix and route the “Virtual E - Front Center Full” channel to

the desired output channels (as described in workow step 2) to which the center processing shall be

applied.

3. Now switch to the FX menu and activate the desired sound e󰀨ect in the “Center Processing” tab by

setting the appropriate check mark.

Notes for front processing with its StageXpander, ClarityXpander, and StageEQ features

The StageXpander and Front ClarityXpander settings always a󰀨ect the virtual channels “Front L Full” and

“Front R Full”.

The StageEQ function can be used to inuence the tonal balance of the center and side information of a

stereo signal. While the Mid EQ a󰀨ects the monaural content, the Side EQ only a󰀨ects the stereo informa-

tion.

Hints for “Augmented Bass Processing” with its “Dynamic Bass Enhancement” and “SubXpander”

function

For Augmented Bass Processing certain settings have to be made in order to use it.

1. An input signal has to be assigned to at least one of the virtual subwoofer channels (“Subwoofer 1” or

“Subwoofer 2”) (see workow step 1).

2. Change to the “Virtual to Output Routing” matrix and route the channel (s) “Virtual K - Subwoofer 1” and /

or “Virtual L - Subwoofer 2” to the desired output channel or channels (as described in workow step 2)

to which the subwoofer signal and its Augmented Bass Processing shall be applied to.

3. Now switch to the FX menu and activate the desired sound e󰀨ect.

For information about input routing

see workow step 1

For information about output routing

see workow step 2

Note: the bass processing is switched on and o

together for both “Subwoofer 1” and “Subwoofer 2”

channels, nevertheless the two channels still remain

separately processed for stereo applications.

Conguration of the Virtual Channel Processing (VCP)

HELIX DSP ULTRA User Manual

Questions and Answers: