Need help?Do you have a question about the Hellenbrand PM6 IC Storm 10 and is the answer not in the manual?
General| Brand | Hellenbrand |
|---|---|
| Model | PM6 IC Storm 10 |
| Category | Water Filtration Systems |
| Language | English |
Specifies minimum, optimum, and maximum water pressure requirements for the system.
Details the acceptable range of operating temperatures for the water filter.
Lists accuracy, flow rate range, and gallon range for the system's meter.
Covers current draw and voltage requirements for the unit.
Checks for water pressure, sediment issues, electrical, and existing plumbing condition.
Guidelines for drain line setup and the necessity of a bypass valve.
Illustrates standard filtering and bypass modes of the valve.
Details the valve's diagnostic and shut-off functions.
Step-by-step guide for connecting, initial setup, and soaking the filter media.
Procedures for backwashing and allowing the system to settle post-installation.
Defines acceptable levels for pH, iron, hydrogen sulfide, manganese, and organic matter.
Discusses TDS impact and notes for chlorinated/unsafe water supplies.
Lists filter tank sizes, media capacity, and flow rates for different models.
Provides guidelines for backwash frequency and ozone recharge.
Explains the different displays and how to navigate them.
Details how the system regenerates and the impact of water usage during regeneration.
Instructions on how to initiate manual regeneration for the system.
Guides users through setting the current hour and minutes.
Information on the battery backup for the time clock and replacement.
Addresses common problems like stalled regeneration and blank LCD displays.
Covers incorrect displays, regeneration timing, odor, and pressure issues.
Diagnosing why the ozone unit won't turn on or keeps blowing fuses.
Steps to take when the unit is on but not producing ozone.
Lists parts for metered control and mineral tank assemblies.
Details filter tank models and media replacement parts.
Identifies components for the bypass valve and ozone generator.
Lists parts for the front cover and drive assembly, including motor and PC board.
Details components like drive caps, pistons, O-rings, and back plates.
Identifies parts for the injector system, including various injector assemblies.
Lists components for the refill port plug and tubing.
Details parts for the 3/4" drain line, including elbows and DLFCs.
Lists components for the water meter and meter plug assembly.
Lists components for the complete bypass assembly.
Information about the specialized wrench for valve maintenance.
Lists essential annual checks and cleaning procedures for the system.
Notes on expected component life and battery replacement for the control valve.
Details preset times for regeneration cycles and water usage sequences.
Lists media cubic feet, flow rates, and max concentration limits for each model.
Outlines the warranty duration for various system components and the entire unit.
Details what is not covered by the warranty, including misuse and outdoor installations.
States the exclusive remedies and limitations on liability for warranty claims.
To Next Page
