26
BYPASS VALVE
The nuts and caps are designed to be unscrewed or tightened by hand or with the
special plastic wrench. If necessary a pliers can be used to unscrew the nut or cap.
Do not use a pipe wrench to tighten or loosen nuts or caps. Do not place screwdriver
in slots on caps and/or tap with a hammer.
Do not use pipe dope or other sealants on threads. Teon tape must be used on
threads of the 1” NPT connection and on the threads for the drain line connection.
Teon tape is not necessary on the nut connection nor caps because of o-ring seals.
ITEM NO. ORDER NO. DESCRIPTION QTY
1 102141 Nut 1" Quick Connect 2
2 102437 Split Ring 2
3 102165 O'Ring 215 2
4 102450 Bypass 1" Rotor 2
5 110997 Bypass Cap 2
6 110998 Bypass Handle 2
7 109479 Bypass Rotor Seal Retainer 2
8 102159 O-Ring 135 2
9 102161 O-Ring 112 2
10 102160 O-Ring 214 2
Bypass Valve
(Not Shown) Bypass Vertical Adapter Assembly
ORDER NO. DESCRIPTION QTY
102141 Nut 1" Quick Connect 2
102437 Split Ring 2
102165 O'Ring 215 2
106858 Bypass Verticle Adapter 2
WATER METER AND METER PLUG
1 102141 Nut 1” QC 1
2-4 102051* Meter Assy. 1
3 102687 Turbine Assy. 1
4 102165 O-ring 215 1
5 102231 Meter Plug Assy.** 1
QTY.
ITEM NO.
ORDER NO.
DESCRIPTION
*Order number 102051 includes 102687 and 102165, which are item
numbers 3 & 4.
**Only used if metering is not to be done (time clock units)
The nuts and caps are designed to be unscrewed or tightened by hand or
with the special plastic wrench. If necessary a pliers can be used to un-
screw the nut or cap. Do not use a pipe wrench to tighten or loosen nuts or
caps. Do not place screwdriver in slots on caps and/or tap with a hammer.
Figure 20
Figure 21
To Next Page