Heraeus Digilance V - 4.7 Power Management

26 November 2018 Digilance V page 13 of 21
File name: Digilance V_1.01
Version: 1.01
4.4 Measurement History
The Digilance stores the last 500 measurements in the History section, accessed from the Main Menu.
• Scroll through the Measurement Results using and when the result list (e.g. ‘1 of 500’) is
highlighted
• Additional measurement information can be accessed by pressing and using and to
change pages, when the page number (e.g. ‘Page 1’) is highlighted
• Measurement Result can be re-transmitted using Page 3 of the History (Only Wireless Devices)
• The Measurement History can only be cleared by the Administrator (See Section ‘Instrument
Configuration’)
4.5 Additional Measurement Information
The Digilance has the possibility to label measurements with additional information, such as Heat Number and
Place, to connect the results with the production process.
Configuration Section
ID
Function
Set Heat Number
3.1.1
Configure the Heat Number Value (Alphanumeric, 10 digits)
Display Heat Number
3.1.2
If set to ‘Yes’ it is possible to enter Heat Numbers from the Main
Measurement Display
Set Place1 – 8
3.2.1 – 8
Configure the List of Eight Measurement Place Names (Alphanumeric,
10 digits)
Display Place
3.2.9
If set to ‘Yes’ it is possible to select the Measurement Place from the
Main Measurement Display
4.5.1 Working with Heat Numbers
• Set Parameter ‘Display Heat Number’ (3.1.2) to ‘Yes’
• On the Main Measurement Display, edit the Heat Number by pressing
• Use and to adjust the value for each digit
• Use to advance to the next digit
• Press to exit the edit function and finalize the Heat Number value
• Once a new Heat Number is entered, will appear next to the value until a measurement is taken
• When Checkmate Measurements are detected:
o The Heat Number will be stored as 9999999999
o will be displayed after the Heat Number
4.5.2 Working with Measurement Places
• Configure the Place Names in Parameters ‘Set Place1 – 8’ (3.2.1 – 8)
• Set Parameter ‘Display Place’ (3.2.9) to ‘Yes’
• On the Main Measurement Display, select the Place by pressing
• Use and to scroll through the list of Places
• Press to confirm selection
• Press to cancel
If both Heat Number and Measurement Place are activated, use and to toggle between the two options
on the Main Measurement Display.