Heraeus Digilance V - Instrument Configuration; 5.1 Configuration Login; 5.2 Configuration Parameters

Page 14 of 21 Digilance V 26 November 2018
File name: Digilance V_1.01
Version: 1.01
4.6 Battery Charging
The Digilance utilizes a Lithium Ion Battery Pack. The Battery Pack monitors the conditions and cell output, in
order to protect the Battery Cells from Damage, such as Short Circuit or Excessive Temperatures.
• The Charge Level of the Digilance Battery Pack is show in the Upper-Left Corner of the Display.
• Information on the Status of the Battery Pack can be found in the Main Menu
Warning
:
• Exchange the battery when the Battery State of Health is
below 50%.
• Charge the Battery Pack with included Power Supply (12V DC, 2A) by connecting the Power Supply
Plug to the Charging Jack:
• During the Charging Process, the Charge Status can be viewed by pressing
Charging Process:
Display Message
LED
Status
Setup Charging
Yellow
(Blinking)
Displayed when the Power Supply is initially connected to the device
Charging ...%
Green
(Blinking)
Charge Level Indication
Battery Full 100%
Green
(Stable)
Battery is Fully Charged
Charging Errors:
Display Message
LED
Status
No Charge Power
Yellow
(Blinking)
Power Supply is connected to the device, but there is no charging current
Battery Too Cold
Yellow
(Blinking)
Battery Temperature is below charging limit (0°C)
If the Battery is Too Cold, the charge current is used to heat the pack,
charging will initiate when the temperature is above the minimum limit.
Battery Too Hot
Yellow
(Blinking)
Battery Temperature is above charging limit (45°C)
Over temperature
Yellow
(Blinking)
Battery Temperature is above maximum limit (60°C)
Charging Error
Yellow
(Blinking)
There is a problem with the Battery Pack. Check state of health of
battery. Consult Heraeus Electro-Nite.