TECHNICAL DATA
©
Component
Outer casing
Heat sink (rear panel)
Inner chamber
Components litted in the chamber
Trays
Door seal
Door bearing
Door handle
Control unit
Switchgear unit
Operator control membrane
Feet
Thermal insulation
Filling medium - overtemp. protection device
Leads
Electronic / electrical components
Heating element
Materials used
Galvanized sheet steel, painted RAL 9002
Aluminium
Stainless steel, material No. 1.4301
Stainless steel, material No. 1.4301
Chromium-plated steel wire
Seasoned silicone rubber
PA, glass fiber reinforced
PA, glass liber reinforced
ABS
PC, glass fiber reinforced
PVS, printed polyester foil
PPN
Mineral fiber wool
Polydimethyldisiloxane
PVC -sheathed copper wire
Encapsulated components coated with various
plastics, some mounted on glass fiber reinforced
PCBs with epoxy resin
Stainless steel tubing filled with magnesium oxide
and heating conductors
Fibrous materials used for insulation sre ctassiried is health hazards in somt countrias. AHhough the fibers which may be reteased into
the environment during normat operation do not constitute a serious risk, greater, more hazardous quantities may be released as a
result of Improper handling during repair work or as a result ol mechanical damage.
34/34
50 042 750
Issue: May. 1994
To Next Page
Loading...
