To Next PageTo Next Page
Need help?Do you have a question about the Heraeus UT6760 and is the answer not in the manual?
Details on electrical connection requirements and safety precautions.
Controls for adjusting the air flap for different operating modes.
Details on temperature monitoring and recording instruments.
Explanation of the temperature control systems and their operation.
Information on safety devices for temperature limits.
The main switch for turning the oven on and off.
Detailed operation of the air flap for fresh-air and recirculated-air modes.
Operation and setting of the mechanical 'Heratherm' temperature controller.
Procedure to adjust the temperature controller knob and locking device.
Details on the 'Digicon' electronic controller with digital display.
How to set the desired temperature using the electronic controller.
Information on the 'Digicon S' controller with an interface module.
Connecting the oven for external program control via interface.
How to measure the actual temperature using external sockets.
Overview of 'Thermicon T' and 'Thermicon P' controllers.
Operating instructions for the 'Thermicon T' temperature controller.
Operating instructions for the programmable 'Thermicon P' controller.
Information on the 'Eurotherm type 818' controller.
Explains thermal safety measures and classifications.
Describes thermal safety class 0 and its limitations.
Details on the lack of direct protection and supervision requirements.
Explains thermal safety class 2 and the function of the limit cut-out.
Procedure for setting and testing the adjustable temperature limit cut-out.
How to set the temperature limit cut-out for oven or load protection.
Describes thermal safety class 3.1 and the controller's function.
Operation and setting of the temperature limit controller for excess temperature.
Procedure to set the temperature limit controller for optimal operation.
Explains thermal safety class 3.3 and dual limit control.
Setting the upper limit for overheating protection.
Setting the lower limit for insufficient temperature protection.
Describes functions and operation of various timers.
Procedure to readjust the dial of the mechanical controller if readings are inconsistent.
Pin assignment details for connecting the Eurotherm controller via RS 232.
Pin assignment details for connecting the Eurotherm controller via RS 485.
General
