Need help?Do you have a question about the Heraeus UT 12 P and is the answer not in the manual?
Detailed safety precautions for operation, maintenance, and electrical connections.
Requirements for environment, placement, ventilation, and clearances.
Importance of adequate ventilation and avoiding enclosed spaces.
Proper procedures and safety measures for electrical connection.
Explains the overtemperature protection system and its reset procedure.
Overview of temperature control, time switch, and air speed adjustment.
Introduction to creating and using pre-programmed heating cycles.
How to define custom temperature/time processes.
Explains 'hold', 'stop', and 'CYCL' commands for program ending.
Step-by-step guide to initial unit startup and basic settings.
Instructions for adjusting and storing the desired temperature.
Guide to using pre-programmed functions and creating custom programs.
Initiating the programmed heating process.
Introduction to setting up complex controller programs.
How to begin the programmed sequence.
Example setup for the 'hold' termination command.
Example setup for the 'CYCL' termination command.
Instructions for proper sample placement to ensure even heating.
Procedures for safely turning off and preparing the unit for storage.
Steps for cleaning units that have handled hazardous materials.
Routine cleaning procedures for the unit's interior and exterior.
General| Power Supply | 230 V, 50/60 Hz |
|---|---|
| Volume | 12 l |
| Temperature Stability | ±0.5°C |
| Material | Stainless steel |
| Safety Features | Over-temperature protection |
To Next Page
