HermanMiller Eames - Step 3; 3.1 Thread jam nut; 3.2 Threaded rod into top casting; Step 4

HermanMiller Eames
®
Table Assembly Instructions2
3.1
Thread jam nut on one end of threaded rod until jam nut stops.
Step 3
3.2
Threaded rod end with jam nut all the way into the top casting. Tighten jam nut against top
casting.
4.1
Place tube over rod onto top casting.
Step 4
5.1
Place spreader assembly into slot in tubes, when applicable.
6.1
Insert legs into slots in the tubes.
Step 5 Step 6