Z
© 2013 Herman Miller, Inc. Zeeland, Michigan. Printed in the U.S.A.
® Y, Z, Mirra 2 are among the registered trademarks of Herman Miller, Inc.
TM
Sense, Setu, and Tu are among the trademarks of Herman Miller, Inc.
Illustrations and specifications are based on the latest product information available at the time of publication.
The right is reserved to make changes in design and specifications at any time, without notice, and also to discontinue products.
Part no. 1BBSDT rev B.
1
Y
Mirra 2
®
Back Replacement
1. Lay chair on the side. 2. Remove the D-Plug from
the retainer hole using the
small screw driver. Repeat it
for the opposite side.
Parts Included:
Steps:
Back Assembly
Small Flat Head
Screw Driver
Ratchet Wrench T40 Torx Bit
Tools Required:
To Next Page
