HermanMiller Setu Disassembly Instructions

1
Z
© 2010 Herman Miller, Inc. Zeeland, Michigan. Printed in the U.S.A.
® Y, Z, Action Office, Mirra and Setu are among the registered trademarks of Herman MIller, Inc. Part no. 1b5vn8 rev A.
Vivo® is among the trademarks of Herman Miller, Inc.
Illustrations and specifications are based on the latest product information available at the time of publication.
The right is reserved to make changes in design and specifications at any time, without notice, and also to discontinue products.
Y
Setu® Disassembly Instructions
Tools Needed:
2 lbs Hammer
Small Flathead
Screwdriver
T-20 Torx Driver
Power Driver
T-27 Torx Bit
(2.75” or longer)
Disassembly Steps:
1
1.1. Lay chair on back.
2
2.1. Grasp and pull to remove Casters
from the Base.
Caster
Utility KnifeSafety Glasses
Where possible, plastic components are marked with recycling codes. Use these codes to identify material type
for recycling. Non marked components should be treated as mixed plastic. Ferrous metals can be identified using
a small magnet for recycling. Non-ferrous metals should be separated and recycled separately.
Materials Identification and Segregation:

HermanMiller Setu Specifications

General

Type	Office Chair
Base Material	Aluminum
Weight Capacity	300 lbs
Warranty	12 years
Material	Woven Fabric or Leather
Adjustability	Height
Arm Type	Fixed