8
Machine Positioning and Installation
Instructions for correct positioning
Be certain to respect the following details while positioning the machine:
• Place the machine on a steady, horizontal surface by using a level.
• The area must be well ventilated. To avoid drying of colourants, make sure the
machine is not exposed to the sun or near heaters or any other source of heat.
• The surrounding temperature should be kept as constant as possible, around 18°C
(and always between 15 and 40°C) so as to prevent variations in the specific weight
and viscosity of the colorants.
• Make sure the machine is connected only to a wall socket installed according to
regulations, with its grounding circuit and voltage value in compliance with what is
written on the machine’s information plate.
Machine unpacking
• Remove the external nylon film from the package
• Remove the fastening straps placed around the outside of the packaging box
• Remove the packaging box by lifting it above the unit
Pallet removal and machine positioning
Due to its weight, between 62Kg and 72Kg, this must be done by a minimum of two
persons. Place the machine where it is intended to be put to use.
To Next Page
Loading...
