7
Safety Instructions
Please read the instructions carefully before installing and operating the dispenser, as a
personal safety measure as well as to avoid needless damage to the equipment.
HERO EUROPE declines any responsibility should the following instructions not be
followed:
• Do not turn on a damaged machine (for example, if the machine is damaged during
transportation). If in doubt, first contact the service department or the reseller.
• Position and connect the machine by carefully following the installation instructions
and by respecting the conditions stated in this manual.
• All the instructions and local safety regulations must be observed.
• The machine must only be connected to a wall electrical socket installed according
to regulations, with the grounding circuit and the voltage value in compliance with
what is written on the machine’s information plate.
• The user must maintain the machine in good working condition and replace any
broken components.
• Any service on the machine, other than routine, can only be carried out by a
qualified technician. Make sure that the power cable is not plugged into the
socket while the machine is being repaired.
• A standard machine is solely suited to dispensing water-based colourants into
standard paint cans.
• The elastomeric parts inside the dispensing circuits could be damaged if other
thinners, i.e., solvent-based colourants are used.
• Never run the pumps without colourant in the respective canister, otherwise the
friction within the pumps will lead to an increase in temperature capable of
damaging the pumps.
To Next Page
Loading...
