(1) Boot lamp (2) Switch
(h) USB charger
A USB charger (1) with a cap (2) located in
the inner rack (3) is provided in your vehicle
to charge your mobile phone safely while
riding.
(1) USB charger (2) Cap
(3) Inner rack
1 3
2
To connect a mobile phone charger cable, first
remove the cap from the USB charger and
then plug in the charging cable to it.
1
2
26
CAUTION
!!
•
Always place the device in a soft clean
cloth/towel to avoid any damage due to road
shocks while riding.
•
Multiple charging of USB devices have to be
avoided, simultaneous charging may lead to
slow or no charging.
•
This port is for charging compatible USB
devices.
•
Charge your device only when the engine is
operational/while riding. Charging the USB
device when the engine is “OFF” would lead
to early discharge of battery.
•
Do not leave the USB device and USB cable
in the inner rack when the vehicle is parked.
NOTE
•
Any personal belongings have to be removed
before water washing to avoid damage.
•
Always keep the USB port cap closed after
use to prevent dust or water entry during
rains/water wash.
•
Do not apply any soap solution, oil or grease
inside the USB charger.
•
Do not direct water jet towards the port even
with cap closed to avoid any short circuit.
Always dry the area using a dry cloth or
moisture free compressed air before use.
Hero MotoCorp will not be responsible for
damages caused due to use of non-standard
USB cable.
Use of non-standard USB cable may cause
damage to the mobile phones.
To Next Page
Loading...
