Note-2 : Throttle play to be checked and adjusted as per given specification
Note-5 : Replace once in every 12000 km.
Note-9 : Service more frequently if the vehicle is ridden in unusually wet or dusty areas.
I: INSPECT C: CLEAN R: REPLACE A: ADJUST L:LUBRICATE T: TOP UP
Ensure that each paid service is availed within 90 days or 3000 km from the date of previous service,
whichever is earlier.
To be serviced by your unless the ownerAuthorised Distributor/Dealer
has the relevant tools, technical information and is technically qualified.
Note-7 : Replace once in every 10000 km or once in a year, whichever is earlier. Replacement requires
mechanical skill.
E: EMISSION CHECK
Note-1 : At higher odometer readings, repeat the frequency interval established here.
*At 12000 km inspect if air cleaner . If found choked, replace the air cleaner element is choked
element to keep the engine healthy.
Note-4 : Service more frequently when riding in rain or at full throttle.
Perform the pre-ride inspection (page 34) at each scheduled maintenance period.
MAINTENANCE SCHEDULE
The following maintenance schedule specifies all maintenance required to keep your vehicle in peak operating
condition. Maintenance work should be performed in accordance with standards and specifications of Hero
MotoCorp by properly trained and equipped technicians. Your meets all of Authorised Distributor/Dealer
these requirements.
In the interest of safety, we recommend that these jobs are carried out only by
your .Authorised Distributor/Dealer
Note-3 : Replace air cleaner element once in every 15000 km or early replacement may be required
when riding in dusty areas.
Note-6 : Replace engine oil once in every 6000 km. Top up if the oil level is at or near the lower level
mark.
Note-8 : Clean carburetor if required after inspection during service.
Note-10: Replace the pinion starter assembly once in every 2 years or 21000 km, whichever is earlier.
Note-11: Replace drive belt once in every 24000 km.
Note-12: Replace the front fork oil once in every 2 years or 20000 km, whichever is earlier.
Note-13: Inspect for any play in the mounting bushes, replace if necessary.
Note-14: Inspect the bearings free play, replace if necessary.
Note-15: Inspect if side stand switch is installed.
Note-16: Check idle CO emission along with idle rpm/idle CO adjustment (if required).
47
To Next Page
Loading...
