HESA INFORMA 600 - Voice Messages

VOICE MESSAGES
At this step of the programming, voice messages sent by INFORMA 600 are recorded
when the dialler is alarmed. The messages can also be reproduced.
When “VOICE MESSAGES” is on the display and [ OK ] is pressed, the following voice
messages sub-menu is viewed:
“VOICE MESSAGES” SUB-MENU
Viewing Description Default voice messages
VOICE MESSAGES
MESS.1 R=# A=*
Messages associated
to channel 1
Burglary alarm
VOICE MESSAGES
MESS.2
R=# A=*
Message associated
to channel 2
Robbery alarm
VOICE MESSAGES
MESS.3
R=# A=*
Message associated
to channel 3
No message
VOICE MESSAGES
MESS.4
R=# A=*
Messages associated
to channel 4
No message
VOICE MESSAGES
MESS.BS
R=# A=*
Message associated to
dead battery failure
Dead battery
VOICE MESSAGES
MESS.AL
R=# A=*
Message associated to
phone line failure
Lack of connection
VOICE MESSAGES
MESS.
A
G R=# A=*
Message associated
to GSM failure
GSM failure
Each message lasts for 15 seconds maximum.
Recording and reproducing
✔ To correctly record voice messages, it is necessary to record the
messages with a clear and firm voice, at a 10 cm distance from the
microphone slots which are at the left hand side of INFORMA 600. There
are some pre-recorded default messages which can be reproduced by
pressing
[*PLA Y].
• Use [ ▲ ] [ ▼ ] to go to MESS n R=# A=* where “n” is the number of the failure
message from 1 to 4.
• Press [ *PLAY ] to reproduce this message. To record a new message:
• Press [ #REC ] to start the recording. A bar graph, made up of small squares
■■■■■■ , will appear on the display to indicate the remaining time. The
recording can continue until the end, and can be stopped beforehand by
pressing [ *PLAY ].
• The message can be reproduced again by pressing [ *REC ]. This can be repeated as
many times as necessary.
22 INFORMA 600 - Multifunction phone dialler with voice synthesis