INSTALLER CODE, USER CODE, STOP CODE
The installer default code is
123456
.
The default user code is
987654
.
The default stop code is
654321
.
To view the present programmed code:
Press [
▲
] and [
▼
] to move upwards or downwards in the programming main menu,
until the required code is viewed. Press [
OK
] to view the code.
To modify the code
.
• Enter the new 6-digit code.
• Press [
OK
] to confirm. Return to the main menu.
• Or, press [
CLR
] to cancel the entry and start again. Press [
CLR
] to return to the
main menu.
✔
The installer, user, and stop codes are to be different. Similar codes will not
be accepted.
.
SCHEDULER
With this programming step, it is possible to enter into the scheduler sub-menu
through which the dialler can automatically activate/deactivate outputs 1 and 2, at the
programmed date and time.
When “SELECT SCHEDULER FUNCTION” is displayed, press
[OK]
to access the
sub-menu, and use [
▲
] [
▼
] to run through the various headings.
The first heading is “SCHEDULER ON/OFF”, which enables/disables the 6
schedules.
Press
[OK]
and then select the schedule number, from 1 to 6, to be
activated/deactivated. Use [
▲
] [
▼
] to enable the schedule (ON) and disable it (OFF).
When “SCHEDULER INS/PROG. MOD.” is displayed, press
[OK]
then select the
number of the schedule from 1 to 6. “PROGRAMME 1” will appear on the display. Use
the key pad, just like in any other mobile phone, to compose the SMS text message and
describe programme 1: Examples “PROGRAMME 1 condition ….
Press
[OK]
to access the relating sub-menu.
INFORMA
600
-
Multifunction phone dialler with voice synthesis
27
To Next Page