COMMAND OPTIONS
With this heading it is possible to programme the command options of outputs 1 and 2.
Associating a command to an input, the dialler checks the command status being
executed, and reads the associated input status. The input function is lost upon
associating a command to an input.
When “COMMAND OPTIONS FUNCTION SELECTION” appears on the display, press
[
OK
] and use [
▲
] and [
▼
] to select “COMMAND 1” or “COMMAND 2”; press [
OK
] to
select the required command, and press [
▲
] and [
▼
] to choose the programming of the
required command; press [
OK
] to confirm or [
CLR
] to exit.
WARNING
:
If the output is programmed as IMPULSIVE, the command status is that of
the associated input and not of the output status.
COMMAND OPTIONS SUB-MENU
COMMAND
1
OPTION
COMMAND
2
OPTION
ASSOCIATED
INPUT
NON
INPUT
1
INPUT
INPUT
3
INPUT
4
FORCED INPUT
GSM CALL
SYSTEM STATUS
INPUT
CALL BLOCK INPUT
ASSOCIATED INPUT
NON
INPUT
1
INPUT
INPUT
3
INPUT
4
FORCED INPUT
GSM CALL
SYSTEM STATUS
INPUT
CALL BLOCK INPUT
CLIP FUNCTION
NO
SI
CLIP FUNCTION
NO
YES
ACTIVATION
COMMAND
MESSAGE
NO MESSAGE
MESSAGE RECORDING
ACTIVATION
ACTIVATION COMMAND
MESSAGE
NO MESSAGE
ACTIVATION MESSAGE
RECORDING
DEACTIVATION
COMMAND
MESSAGE
NO MESSAGE
MESSAGE RECORDING
DEACTIVATION
DEACTIVATION
COMMAND MESSAGE
NO MESSAGE
DEACTIVATION MESSAGE
RECORDING
ACTIVATION
COMMAND
DESCRIPTION
1
A
CTIVATED
ACTIVATION COMMAND
DESCRIPTION
2
A
CTIVATED
DEACTIVATION
COMMAND
DESCRIPTION
1
DEACTIVATED
DEACTIVATION
COMMAND MESSAGE
2
DEACTIVATED
SMS
ACTIVATION
COMMAND
ON1
SMS
ACTIVATION
COMMAND
ON2
SMS DEACTIVATION
COMMAND
OFF1
SMS DEACTIVATION
COMMAND
OFF2
✔
Default options are in bold
32
INFORMA
600
-
Multifunction phone dialler with voice synthesis
To Next Page