Output 5 is programmed to subsequently be enabled by one of the following event
conditions:
▼
dead battery (the power level is below 85% the rated value)
▼
failed call: starts when a call has not been successful
▼
call [OK]: starts when at least one call is successful
▼
call in progress: starts during an alarm call
It is possible to programme the following for each output:
Rest status: deactivated (negative at events), activated (negative at rest), stable or
impulsive output: in case of impulsive output, the duration can be programmed from 1
to 15 seconds.
It is also possible to programme the following for the first 2 outputs (those which can be
activated locally and remotely) :
▼
The associated input, among the seven available ones, is the one that reports the
real executed command
▼
The CLIP function, or else, when this output is activated with the CLIP function.
▼
SMS message (6 characters max): sent to activate the output with an SMS.
▼
SMS message (6 characters max.):sent to deactivate the output with SMS.
▼
Il SMS message (14 characters max.): with which the equipment answers,
upon an activation with SMS.
▼
Il SMS message (14 characters max.): with which the equipment answers,
upon a deactivation with SMS.
■
Alarm memory
INFORMA 600 can memorise up to 64 alarms. It is possible to have further details
about each memorised alarm, such as the channel enabled, date, time, and numbers
called.
■
Programming
Local programming: by using the key pad, and LCD display which is built-in by a guided
menu. Local programming is through PC (with an installed programming software), and
a suitable serial cable. Remote programming is (only in PSTN+GSM version) by
sending SMS messages from a PC (with an installed programming software) and a
suitable SMS modem.
■
Phone numbers
It is possible to programme up to 24 phone numbers, each of which can have 20 digits maximum.
It is possible to associate each phone number with one or more event voice messages (input
alarm, dead battery, phone line failure and GSM failure), and to one or more SMS event messages
(input alarm, dead battery, phone line failure, GSM low remaining credit, SIM GSM card due to
expire). When a channel is alarmed, or when the alarm situation occurs, the dialler calls the phone
numbers chosen for the event.
INFORMA
600
-
Multifunction phone dialler with voice synthesis
9
To Next Page