14
If the system does not operate after normal start-up as
described in Operation Section of this manual, follow
the recommended troubleshooting sequence to help
isolate the cause and determine corrective action.
The BMS-2 Receiver displays Operational Status and
Error Codes to help diagnose problems that may occur
with the system. The Operational Status codes are
shown in the Operation Section of this manual.
Error Codes are defined by the customer. See
Technical Documentation provided with your system for
specific Error Codes. If the Error Code is not listed in
your Technical Documentation, please contact Hetronic
or your Dealer for more information.
If the system will not respond to the steps below or the
Receiver Display indicates a failure, contact the
Hetronic Service Department or your authorized dealer.
TROUBLESHOOTING
PROBLEM PROBABLE CAUSE CORRECTION
System will not initialize
after normal start-up
procedure
E-Stop reset Push the Start button again. If the system is
being initialized from an E-Stop condition,
the Start button must be pressed twice - first
to clear the E-Stop, then again, to start the
system.
Joystick or paddle lever not in
center position
Be sure that all joysticks and paddle levers
are in center position when the Start button
is activated.
E-Stop switch engaged Pull out E-Stop switch. Restart system by
pressing Start twice.
Battery fully discharged Check battery to ensure a full charge.
Replace with fully charged battery if
necessary.
No power to the receiver Check the diagnostic Display on the side of
the receiver to be sure power is applied.
Ensure that the system is securely
grounded to the negative battery terminal.
The Display also indicates normal
transmitter communication, interference,
and E-Stop conditions.
The transmitter is
turned on, but does not
transmit (Power LED
not flashing)
Battery is discharged Replace battery with a fully charged battery.
Coder board fuse Check fuse and replace if necessary.
Broken key switch Check wiring on key switch. Replace key
switch, wiring or contact element.
Coder board failure Contact Hetronic or your Dealer.
To Next Page
Loading...
