HGI Generators HRD060D - Starting; Stopping; Stopping and Starting Remotely

Harrington Generators International
23
498-1084 HRD060D Diesel Generator
Operation
Starting
WARNING
Please check that all equipment is disconnected
from the generator prior to starting.
1. Review the Safety Precautions.
2. Perform Preoperational checks.
3. Turn the DC Isolation Switch to the ON position.
4. Press the red Reset Button
on the Engine
Control module.
5. Press the green START
button on the
DSE3110 controller once. (The run/start indicator
will illuminate).
6. Wait approximately 10 seconds while engine
preheats.
7. Allow the engine to warm up for 1 minute before
connecting any load to the generator output.
8. Connect the equipment to be powered (load) into
the socket outlets on the generator control panel.
Check that the total load from all equipment con-
nected does not exceed the generator rating.
If the engine fails to start after 3 attempts then initiate
fault nding to rectify the problem.
NOTICE
If the generator is not required switch it off and avoid
running with light or no load wherever possible. Also
see Maintenance Section.
Stopping
1. Switch off the electrical output and disconnect the
load from the generator’s output.
2. Allow the generator to run off load for 2 minutes to
cool down.
3. Press the red STOP
button.
Stopping and Starting Remotely
To use the generator remotely the third party remote
control panel will need to be connected to the remote
connection socket on the control panel.
Once connected:
1. Press the red Reset Button
on the Engine
Control module on the generator control panel.
2. Press the white Auto
button on the generators
DSE3110 control module.
Typically, the remote control panel will have run and
stop buttons / switches. If using an HGI CN222 control
panel:
3. To start, press the Green Run/Go button
on
the remote control.
4. To stop press the Red Stop button
on the
remote control.
If the remote control panel has a timer facility (as
with the HGI CN222) it will, typically, have been
programmed to run the generator for a preset time.
This timer countdown begins once the Green button
has been pressed.
If you should require generator power after the time
has elapsed then press the green button once more to
restart the timer.
5. Should you require to stop the generator from the
remote control panel then press the Red button.