7PLT-04233, Rev. A.3
HID Aero™ X1100 Installation Guide
Powering
Trusted Identities
Specifications
AERO X1100
Input Voltage 12 to 24 V DC ±10%
Maximum Input Current 1.9 A (550 mA excluding readers and USB)
Micro USB Port 5 V DC, 500 mA maximum (reserved for future use)
Memory and Clock Backup Battery 3 Volt Lithium, type CR2032
microSD Card Format: microSD or microSDHC; 2GB to 8GB (reserved for future use)
Host Communication
Ethernet: 10Base T/100Base-TX
Micro-USB port (2.0)
IO Modules
Two independent ports: 2-wire RS-485, 2,400 to 115,200 bps, asynchronous,
half-duplex, 1 start bit, 8 data bits, and 1 stop bit
Inputs
Seven unsupervised/supervised, standard EOL: 1k/1kΩ, 1%, ¼ watt
(Includes TAMPER, AC FAIL, and BATT FAIL inputs)
UL evaluation for access control use only
Output
Four relays, Form-C with dry contacts:
Normally open contact (NO): 5 A @ 30 V DC resistive
Normally closed contact (NC): 3 A @ 30 V DC resistive
READER INTERFACE
Power 12 V DC ±10%, 500 mA maximum each reader
Data Inputs TTL compatible or 2-wire RS-485
OSDP (RS-485) Mode
9,600 to 230,400 bps, asynchronous, half-duplex, 1 start bit, 8 data bits,
and 1 stop bit. Maximum cable length: 2000 ft. (609.6 m)
LED Output
Open collector, 12 V DC open circuit maximum, 40 mA sink maximum
Beeper Output
ENVIRONMENTAL
Operating Temperature 32 to 158°F (0 to +70°C)
Storage Temperature -67 to 185°F (-55 to +85°C)
Humidity 5 to 85% RHNC
MECHANICAL
Dimension 6.46" × 5.51" × 1.02" (164 mm × 140 mm × 26 mm)
Weight 352 g
These specifications are subject to change without notice.
To Next Page
Loading...
