March 2016 Page 4 of 16
DTC5500LMX Card Printer Cleaning Kit Instruction, PLT-02707, Rev. 1.1
1 Safety Messages (review carefully)
Symbol Critical Instructions for Safety Purposes
Danger:
Failure to follow these installation guidelines can result in death or serious
injury.
Information that raises potential safety issues is indicated by a warning symbol
(as shown to the left).
• To prevent personal injury, refer to the following safety messages
before performing an operation preceded by this symbol.
• To prevent personal injury, always remove the power cord prior to
performing repair procedures, unless otherwise specified.
• To prevent personal injury, make sure only qualified personnel perform
these procedures.
ESD:
This device is electrostatically sensitive. It may be damaged if exposed to
static electricity discharges.
Information that raises potential electrostatic safety issues is indicated by a
warning symbol (as shown to the left).
• To prevent equipment or media damage, refer to the following safety
messages before performing an operation preceded by this symbol.
• To prevent equipment or media damage, observe all established
Electrostatic Discharge (ESD) procedures while handling cables in or
near the Circuit Board and Printhead Assemblies.
• To prevent equipment or media damage, always wear an appropriate
personal grounding device (e.g., a high quality wrist strap grounded to
avoid potential damage).
• To prevent equipment or media damage, always remove the Ribbon
and Cards from the Printer before making any repairs, unless otherwise
specified.
• To prevent equipment or media damage, take jewelry off of fingers and
hands, as well as thoroughly clean hands to remove oil and debris before
working on the Printer.
Caution:
This symbol signifies electrical danger which may cause injury or death.
To Next Page
Loading...
