HID FARGO HDP 6600 X002200 - Installing Blank Cards into the Input Card Hopper

28 September 2018
Setup and installation PLT-02931, Rev. A.0
2.7 Installing blank cards into the input card hopper
Load the cards with the print side down and (if applicable) the magnetic stripe up and towards the front of
the printer.
Notes:
႑ FARGO UltraCard® Premium card types are recommended (see Section 2.7.1 General card information).
႑ Cards eject into the output hopper or reject hopper.
႑ Each input hopper holds 100 cards.
1. Press the button to open the card input cartridge.
2. Load blank cards then close the card input cartridge.
Note: If using cards with a magnetic stripe, load the cards with the stripe facing up and towards the
front of the printer.
3. Close the input card hopper door.