To Next Page

To Previous Page

August 2005 Page 11 of 23

VertX V2000 (CS) Quick Installation Guide

3.2 Computer to VertX Controller Connection

Note: This step is necessary if you are configuring your communications for DHCP or Static TCP/IP.

3.2.1 Hardware Requirements

The following outlines the hardware requirements for configuring a static TCP/IP connection.

• Computer with administration rights and a Internet browser, Internet Explorer 5.0 (or greater), or

equivalent.

• Ethernet cable

• Optional Hub – Required if primary communication channel is Ethernet.

Connect the computer to the VertX controller using an Ethernet cable.

3.3 Windows TCP/IP Configuration

Prior to proceeding, document your Network Connections settings, in order to change your settings back to

their original configuration.

CAUTION: During the timeframe in which you have changed the TCP/IP settings on your computer,

you will not have access to the Internet or E-mail.

Depending on your operating system, follow one of the listed procedures.

• Windows XP Computers

• Windows 2000 Computers

•

Questions and Answers:

Need help?

Do you have a question about the HID VertXHID V2000 and is the answer not in the manual?

HID VertXHID V2000 Specifications

General