Chapter
3
September 2017 25
Print Driver Installation
This section describes the printer driver installation requirements and standard procedures.
The DTC1500 Print Driver supports the following:
Windows Server 2003 R1 and R2 (32-bit)
Windows Server 2008 R1 (32- and 64-bit)
Windows Server 2008 R2 (64-bit)
Windows Server 2012 R1 and R2
Windows 7 (32- and 64-bit)
Windows 8 (32- and 64-bit)
Windows 10 (32- and 64-bit)
For more information on supported operating systems, see www.hidglobal.com/support.
3.1 Driver Installation Instructions
Note: You must be logged in as an administrator to perform the driver installation. After installation,
from Printer & Faxes, select Printer properties. The Security tab must allow you to set the Print,
Manage this printer and Manage documents permissions.
Start by downloading the latest driver file from www.hidglobal.com/drivers. Follow the Installaware
Wizard screen prompts.
1. Select Install the Printer Driver to start the driver installation.
2. Select the Fargo Workbench Utility Program to install the diagnostic program.
3. All versions of Windows require Administrator rights.
4. From the Printer & Faxes, select Printing preferences to set up the printer driver after it has
been installed.
5. Use the drop-down arrows to select the correct options for each printing preference.
To Next Page
Loading...
