Section 4 - Operating the Mower
Page 4-5
10. Allow the Wings to Float.
- The wing connections float in the slot
area of the wing lift links.
- Fully extend the wing lift cylinders.
This will allow the wings to follow the
contour of uneven ground.
- If a wing seems to lower, re-phase the
wing height cylinders by fully raising
the mower. Hold the lever open for at
least 30 seconds to ensure the
cylinders are synchronized.
11. Avoid Cutting Into the Ditch
- On uneven areas, prevent the blades
from cutting into gravel or dirt by
positioning a support wheel near the
highest point.
12. Rotate the Deck to Swing the Mower
Away from Obstructions
- Rotate the deck to move the mower
away from obstructions such as
culverts or large rocks.
- Do not rotate the mower into following
or on-coming traffic.
- If an object is hit, immediately stop
driving and disengage the PTO.
-Wait for all rotating parts to stop.
-Raise the mower and drive away
from the object.
-Check the mower for damage.
Allow Wings to Float
107039
Mower Deck On Uneven Area
107075C
Rotate Mower Away from Obstructions
107055
To Next Page
Loading...