Section 5 - Maintaining the Mower
Page 5-6
Splitter Gearbox Oil Change
1. The Splitter gearbox is located on the
center section of the mower.
Before beginning, make sure the
tractor is off and the PTO is
disengaged. Disconnect the
driveline from the tractor before
doing any work.
Securely block-up the mower
before any work is done under the
mower when lifted up. This is to
prevent the mower from dropping
due to inadvertent operation of
controls, hydraulic leaking or
failure of any components.
2. Remove the Center Section Blade Pan to
gain access to the drain plug. Use the
Blade Pan Removing and Replacing
procedures outlined in this Manual.
3. The oil drain plug (1) is located on the
gearbox vertical shaft casing.
4. Remove the drain plug and drain the oil.
Collect the oil in an environmentally
friendly container.
5. Replace the drain plug.
6. Replace the Blade Pan using the Blade
Pan Removing and Replacing procedures
outlined in this Manual.
7. Refill with the specified oil type through
the fill plug.
8. Dispose of the container at an appropriate
oil recycling center.
Splitter Box Oil Drain Plug
108028C
To Next Page
Loading...