HighPoint NVMe Boot RAID Windows Installation Guide
12
Step 2 - Install Windows
a. Enter the Boot list, and select start from UEFI BOOT:
b. After Windows setup begins, follow the on-screen prompts. When Windows asks “Where
do you want to install Windows?”, you should see several Legacy disks available (one for
each SSD you have installed into the NVMe product).
Note: The screenshot below shows 4 SSD’s that have been installed into a SSD7505
controller:
c. Install Windows, to “Where do you want to install Windows?”; Click “Load driver” ，
in the pup-up window, click “Cancel”.
To Next Page
Loading...
