ii
Battery
CAUTION: Risk of explosion if the battery is replaced by an incorrect type. Replace with
the same or equivalent type only. Dispose of used batteries in conformance with the
instructions provided by the battery manufacturer.
Improper replacement of the battery with an incorrect type may defeat a safeguard (for
example, in the case of some lithium battery types).
Do not dispose of the battery into fire or a hot oven, or mechanically crush or cut the
battery, which may result in an explosion.
Do not leave the battery in an extremely high temperature surrounding environment,
which may result in an explosion or the leakage of flammable liquid or gas.
Do not subject the battery to extremely low air pressure, which may result in an
explosion or the leakage of flammable liquid or gas.
Dispose of used batteries in conformance with the instructions provided by the battery
manufacturer.
The built-in battery cannot be dismantled. Please contact the manufacture for repair if
necessary.
For long-term storage of the battery, make sure it is fully charged every half year to
ensure the battery quality. Otherwise, damage may occur.
Use the battery provided by a qualified manufacturer. Refer to the product specification
for detailed battery requirements.
DO NOT charge other battery types with the supplied charger. Confirm there is no
flammable material within 2 m of the charger during charging.
DO NOT place the battery near heating or fire source. Avoid direct sunlight.
DO NOT swallow the battery to avoid chemical burns.
DO NOT place the battery in the reach of children.
When the device is powered off and the battery is full, the time settings can be kept for
60 days.
The standard adapter power supply is 5 V.
Maintenance
If the product does not work properly, please contact your dealer or the nearest service
center. We shall not assume any responsibility for problems caused by unauthorized
repair or maintenance.
Wipe the device gently with a clean cloth and a small quantity of ethanol, if necessary.
If the equipment is used in a manner not specified by the manufacturer, the protection
provided by the device may be impaired.
Your camera will periodically perform a self-calibration to optimize image quality and
measurement accuracy. In this process, the image will pause briefly and you will hear a
“click” as a shutter moves in front of the detector. The self-calibration will be more
frequent during start up or in very cold or hot environments. This is a normal part of
operation to ensure optimum performance for your camera.
To Next Page
Loading...
Need help?
General
