Thermal Imager User Manual
18
Regulatory Information
These clauses apply only to the products bearing the corresponding mark
or information.
FCC Compliance Statement
Please take attention that changes or modification not expressly approved
by the party responsible for compliance could void the user's authority to
operate the equipment. This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
Note: Due to the device size limit, the above statement may not be
disclaimed on the device. This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled environment.
Note: This product has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful
interference in a residential installation. This product generates, uses, and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this product does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
To Next Page
Loading...
Need help?
General
