Thermal Imager User Manual
21
Safety Instruction
These instructions are intended to ensure that user can use the product
correctly to avoid danger or property loss.
Transportation
Keep the device in original or similar packaging while transporting it.
Keep all wrappers after unpacking them for future use. In case of any
failure occurred, you need to return the device to the factory with the
original wrapper. Transportation without the original wrapper may result
in damage on the device and the company shall not take any
responsibilities.
Do not drop the product or subject it to physical shock. Keep the device
away from magnetic interference.
Power Supply
Input voltage should meet the Limited Power Source (5 VDC, 2 A)
according to the IEC62368-1 standard. Please refer to technical
specifications for detailed information.
Make sure the plug is properly connected to the power socket.
DO NOT connect multiple devices to one power adapter, to avoid over-
heating or fire hazards caused by overload.
Use the power adapter provided by qualified manufacturer. Refer to the
product specification for detailed power requirements.
To Next Page
Loading...
Need help?
General
