Hikmicro THUNDER Series - Chapter 6 General Settings

Thermal Image Scope User Manual
21
Chapter 6 General Settings
You can manually record video or capture picture when displaying live view.
6.1 Set OSD
You can choose whether to display the OSD information on the live view interface.
Steps
1. Hold to show the menu.
2. Select , and press to enter the OSD setting interface.
3. Press and to select the OSD information you want to display or not, and press
again to confirm.
4. Hold to save and exit.
Note
You can also press in the live view mode to display or hide all the OSD information quickly.
6.2 Set Brand Logo
You can add brand logo on the live view interface.
Steps
1. Hold to show the menu.
2. Select .
3. Press to enable Brand Logo.
4. Hold to save the settings and exit.
Result
The brand logo is displayed at the bottom right of the image.
Figure 6-1 Brand Logo Display