HIKVISION AX DS-PWA32-HG User Manual

You can set the following parameters:
Enable Arming
When you enable the funcon, during the device arming procedure, the system will check the
congured fault checklist. When there is fault occurred during the arming procedure, the
procedure will be stopped.
Note
PKG keypad and the keyfob do not support this funcon. If this funcon is enabled, the arming
will fail if there is a fault. It is necessary to eliminate the fault or close the Enable Arming.
Fault Checklist
The system will check if the device has the faults in the checklist during the arming procedure.
Enable Arming with Fault
Check the faults in the Enable Arming with Fault list, and the device will not stop the arming
procedure when faults occurred.
Arming Indicator Keeps Light
If the device applies EN standard, by default, the funcon is disabled. In this case, if the device is
armed, the indicator will be solid blue for 5 s. And if the device is disarmed, the indicator will
ash 5 mes.
When the funcon is enabled, if the device is armed, the indicator will be on all the me. And if
the device is disarmed, the indicator will be o.
Note
Only -P model supports this funcon.
Prompt Fault When Arming
If the device applies EN standard, by default, the funcon is disabled. In this case, the device will
not prompt faults during the arming procedure.
Note
Only -P model supports this funcon.
Enable Early Alarm
If you enable the funcon, when the zone is armed and the zone is triggered, the alarm will be
triggered
aer the delay me.
Note
The early alarm will be taken eect only aer the delayed zone is triggered.
AX Security Control Panel
53

HIKVISION AX DS-PWA32-HG Specifications

General

Brand	HIKVISION
Model	AX DS-PWA32-HG
Category	Control Panel
Language	English