Figure 3-12 Motion Detection
ZOOMRATE
You can adjust this feature to change the speed of zoom. The value
ranges from 1 to 5. The value is larger, the speed is higher.
EZOOM
The EZOOM can be set to OFF, x2, x4, x6, x8, x10, x12, x14 and
x16. The maximum optical zoom is 23X. 2 times 23X is 46X. If you
choose x2, the maximum digital zoom can reach to 46X. The
camera zooms electronically after reaching to the value 23x.
ZOOMDISP
There are two ZOOMDISP modes:
ON: The zoom value will be displayed on the top right of the screen
when you press the T/W buttons.
OFF: The zoom value will not be displayed on the top right of the
screen when you press the T/W buttons.
ZCFMOD
The ZCFMOD can be set to MODE1 and MODE2.
When you select the MODE1, the zoom in voltage is from +3V to
+12V. The zoom out voltage is from -3V to -12V.
When you select the MODE2, the zoom in voltage is from -3V to
-12V. The zoom out voltage is from +3V to +12V.
The voltage of the focus near and far is the same as the zoom in
and out in these two modes.
RS-485
To Next Page
Loading...
Need help?
General
