HIKVISION DS-3E1510P - SNMP Proxy Settings; SNMP Trap Settings

4.5.1 SNMP Proxy Sengs
Steps
1. Go to Switch
Conguraon → L2 Conguraon → SNMP Conguraon → SNMP Proxy Sengs
to congure SNMP proxy.
Figure 4-15 Proxy Sengs
1) Enable SNMP.
2)
Dene the Community Name.
Community Name
The community name is an
authencaon mechanism, similar to a password, which is
used to limit the data transmission between NMS and Agent.
• Read-Only Community Name: The Community name accessible to NMS with read
permission. The default is public.
• Read/Write Community Name: The Community name accessible to NMS with read and
write permission. The default is private.
3) Click Save.
4.5.2 SNMP Trap
Sengs
Steps
1. Enable Trap on the SNMP Trap
Sengs page.
Figure 4-16 Trap Sengs
2. Click Add to add a trap.
Gigabit PoE Switch Web User Manual
19