HIKVISION DS-3E1X05P Series - Page 15

3.3 Connecng SFP Opcal Module
Connecng SFP opcal module is supported when the device has a ber opc port or a combo.
When connected to a network cable, the combo is a RJ45 port. When plugged into with an opcal
module and connected to an opcal ber, the combo funcons as a ber opc port.
When connected to both the network cable and
opcal ber at the same me, the port works as a
ber opc port.
Steps
Cauon
• Single-Mode
opcal module needs to be paired.
• Do not bend ber opc (curvature radius ≥ 10 cm) overly.
• Do not look directly at
ber opc connector because the laser is harmful to eyes.
1.
Connect the two paired SFP opcal modules with an opcal ber.
2. Hold the SFP opcal module from one side, and smoothly plug it into the device along with the
SFP port slot unl the opcal module and the device are closely aached.
3. Aer powering on the device, check the status of LINK/ACT indicator. If the indicator is lit, the
link is connected. If the indicator is unlit, the link is disconnected. Check the line, and make sure
peer devices have been started.
100 Mbps PoE Switch Quick Start Guide
8